Video Systems Clock/Radio DVR Uživatelský manuál stáhnout pdf (Strana 15)

SETUP PROCEDURES

OVERVIEW ON SET-UP PROCEDURES

Below is an overview of the installation steps required to operate the Clock/Radio DVR.

Each step is explained in detail in the Hardware Installation section.

(1) Insert a standard capacity SD MEMORY.

(2) Connect the system to a TV set or monitor.

(3) Connect the power.

(4) Plug the unit in to turn the power on.

(5) Start TV Monitoring and recording.

General Operating Advice:

• Make sure that a standard SD Memory, not high capacity is inserted. (See Hardware Installation)

• The firmware used in this device is compatible with your computer’s operating system (i.e. Windows).

Therefore, you can take the SD memory card from this system and install it in your computer to view

recorded video. (Refer to the PC Viewer manual.)

• You will see a blue screen with no camera images. When the system starts up, it enters the default

operational state: VIEW mode. In this mode, the unit does not record nor play the recorded stream. It

just shows the current images from the camera connected to the device.

• The default recording setting for this system is set to 30 frames per second and normal video quality. If

you use 1GB SD Memory, the Clock/Radio DVR can record for 2 hours in a row approximately.

• There is an exception to entering the VIEW mode at start up. If the power is turned off while recording

(i.e. a power failure), the device will enter POWER RECOVERY mode at start up and detect that it has

been shut down by a power failure, it will then reinitiate the recording process.

Refer to the Hardware Installation section for more information on installation proce-

dures.

MICRO DVR MENUS

7.3 BRIGHTNESS

Select brightness value among low, medium and high.

7.4 VIDEO

Select video format between NTSC and PAL.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

Video Systems Clock/Radio DVR Uživatelský manuál Strana 15