Video Systems Clock/Radio DVR Uživatelský manuál stáhnout pdf (Strana 11)

MICRO DVR MENUS

4.2 POST RECORDING TIME: Post recording time means the time between one event and the next

second to 30 minutes can be entered.

4.3 FRAME RATE

NTSC: Selectable among 0.1 / 0.2 / 0.5 / 1 / 3 / 6 / 15 / 30

PAL: Selectable among 0.1 / 0.2 / 0.5 / 1 / 5 / 6 / 8 / 12.5 / 30

4.3.1 PRE RECORDING TIME

High: up to 5 seconds for pre-recording available

Normal: 750Kbps / up to 8 seconds for pre-recording available

Low: 500Kbps / up to 10 seconds for pre-recording available

4.3.2 CURRENT IMAGE: This shows the storage space used in SD memory.

4.3.3 REMAIN MEMORY: This shows remaining storage capacity for further recording.

4.3.4 REMAIN TIME: This shows remaining time for further recording.

NOTE 1: 1.3.1 to 1.3.4 are automatically entered when video quality is set. You cannot change the

values.

NOTE 2: The higher the video quality, the clearer the image will be during playback.

The lower the video quality, the more space you will save on the SD memory.

NOTE 3: The video quality in View Mode is not affected by the video quality setting.

These settings only affect the video quality during playback of recorded video.

5. EVENT MODE

MICRO DVR MENUS

5.1 ALARM SETUP

5.1.1 ALARM INPUT (ON / OFF): Select ‘ON’ if you want to use alarm input device.

5.1.2 TYPE: Select alarm input type between ‘NO’ and ‘NC’

NC: NORMAL CLOSE

NO: NORMAL OPEN

NOTE: In NORMAL-CLOSE mode, if an intruder cuts the cable line that connects the sensor to the de-

vice, sensor recording starts automatically. In NORMAL-OPEN mode, if an intruder cuts the cable line

that connects the sensor to the unit, the sensor recording will not start.

5.1.3 ALARM OUTPUT (ON / OFF): Select ‘ON’ if you want to use alarm output device.

5.1.4 TYPE: Select alarm output type between ‘NO’ and ‘NC’.

5.2 MOTION SETUP

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Žádné komentáře

Video Systems Clock/Radio DVR Uživatelský manuál Strana 11